Eiki LC-X7 Manual de usuario Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
LC-X7 Basic Serial Command Functional Specifications
20/24
7.7 Temp Read Command
COMMAND “CR6” [CR]
Detail
Get the temperature information inside projector
With more than one temperature sensors installed in the projector, it is possible
to get all temperatures at once.
Acceptable “%1_%2_%3” [CR]
%1
%2
%1 = temperature at Sensor 1
%2 = temperature at Sensor 2
%3 = temperature at Sensor 3
Temperature data is expressed as “00.0”.
When the temperature goes under 0, the first character is “-” like
“-05.5” [CR].
When no temperature data returns due to hardware problems
the first character is “E” like” E00.0” [CR].
With more than one temperature sensors installed, the projector
returns the values in series.
Ex) “_31.5_ _35.2_ _33.4” [CR]
Each sensor data follows in sequence with one space between
each of them.
Response
Unacceptable “?” [CR]
7.8 Lamp Mode Read Command
COMMAND “CR7” [CR]
Detail
Get current Lamp Mode in the multiple-lamp projector.
When there is any fail lamp, also can get the information about.
Acceptable “%1” [CR]
%1
ex: ”0F”[CR]
The first digit indicates Lamp Mode.
0 = 2lamp Mode
1 = 1lamp Mode (Lamp No.1 used)
2 = 1lamp Mode (Lamp No.2 used)
The second digit indicates if the lamp is ON or OFF.
Data is shown as “0-9” and “A-F”, which is described in 4-bit
data. Assign each bit for each lamp data.
ex: 0 = ALL is OFF
1 = No.1 is ON, the other is OFF
2 = No.2 is ON, the other is OFF
3 = ALL is ON
Response
Unacceptable “?” [CR]
7.9 PC Type Read Command
COMMAND “CR9” [CR]
Detail Get the currently displayed PC Type
Acceptable “%1” [CR]
%1
“Stand_by” ------------------------------------- Standby
“AV_Mode” ------------------------------------- AV Mode
Current Table such as “UXGA1” ---------- PC Mode
“Go_PC_adj.” --------------------------------- Auto
“No_signal” ------------------------------------ No signal
Response
Unacceptable “?” [CR]
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios