Eiki NPC-1 Manual de usuario descargar pdf (Pagina 11)

- 9 -

Connecting the NPC-1 to a network

There are two ways to use the 10/100BaseT Ethernet jack located on NPC-1’s front

panel:

1. For most applications using NPC-1, you will simply plug one end of an Ethernet cable

(RJ45) into NPC-1’s 100BaseT jack, and plug the other end into a hub connected to

your network. In this case, use a regular

straight-through

Ethernet cable.

2. In some cases, you may connect NPC-1 directly to your computer’s Ethernet card. To

do this you will need to use a

cross-over

Ethernet cable.

The orange/green link light will flicker when NPC-1 is properly connected to a live

Ethernet.

LED Indicators

NPC-1’s top panel contains three LED indicators, as described in the following list.

emaNDELnoitcnuFDEL

rewoPNOsirewopehttahtsetacidnideR

kniL

noitcennoctenrehtEspbM01asetacidniegnarO

noitcennoctenrehtEspbM001asetacidnineerG

ydaeRydaersimetsys1-CPNsetacidnineerG

NetControl software installation

Insert the CD into your CD ROM drive. The installation routine will start automatically. If it

does not start please run “setup.exe” manually.

The installation requires a software registration code. The registration code for the

NetControl software in printed on the back of the CD cover.

System requirements

• Intel® Pentium® II/400 MHz or compatible

• Microsoft® Windows® 98SE, ME, NT (SP5), 2000 (SP3), or XP

• 128 MB RAM

• Network adapter

• Access to TCP/IP network

• 23 MB hard disk space (full install)

• CD-ROM drive

• XGA or higher resolution monitor (1024x768, 256 color)

• Mouse or other pointing device

manual.pmd 3/18/2003, 6:32 PM9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Sin comentarios

Eiki NPC-1 Manual de usuario Pagina 11